JLM-SH26 7.5 lengthened and thickened lock box (unidirectional)

1) Aluminum milling side face: 15mm wide, 86mm long, square shaft hole s9mm, machine wire hole s6mm;
2) Put the lock box on the side of the washed aluminum, tighten the inner hexagon buckle, and fix the lock box on the side of the aluminum;
3) The square shaft of the handle is connected with the lock box, the lock box and the handle are adjusted, and then the long machine wire is connected with the sliding slider
4) When the machine wire is used on the handle to pass through the lock box, the two sliding blocks are pulled out with two machine wires;
5) When the inner space of the aluminum material is less than the length of the slider, directly pull out the slider and tighten the machine wire (at this time, the lock box is not biased)
6) When the inner space of the aluminum material is larger than the length of the slider, first pull out the slider with two machine wires, and then pull out the handle together with the machine wire slider, etc
After the slider is pushed to the inner wall of the aluminum material, tighten the screw inward. The slider and the aluminum material can be tightly fixed, and the handle will not return loose (note that the slider should slide
In the direction of the handle, otherwise the slider is in the opposite direction, which will cause it to be blocked by the lock box and cannot be pulled out.)